BMP 180 problems

[bestes]

HI @dave3 ,

This post might help you. You should not need to add slave address if BMP180 is hooked up properly. Does I2cdetect see your bmp180?

BMP180 -Failed to add the sensor, please re-check your settings. Make sure you selected the correct Channel/Slave Address

If the installation not work. Try to add manually the i2c configuration. Follow this guide to add i2c on your Raspberry Pi. After this you can see the slave address that you must add to Cayenne installation page. Try to write on terminal of Raspberry Pi: sudo apt-get update sudo apt-get install i2c-tools sudo i2cdetect -y 1 Now you can see the address. The address is ever 40.

~B