Hi Cayenne Community;
I’m actually searching to connect a TEMT 6000 on cayenne.
I tryed to simulate a VCNL4000 sensor on place from the TEMT 6000, but no success…
Someone have a issue to get working this ?
Thank’s for our answers!
Regards
Hi Cayenne Community;
I’m actually searching to connect a TEMT 6000 on cayenne.
I tryed to simulate a VCNL4000 sensor on place from the TEMT 6000, but no success…
Someone have a issue to get working this ?
Thank’s for our answers!
Regards
are you trying to add it to an arduino device or raspberry ?
Yes, i’m trying with my RPI 3 on GPIO 4 ( for signal) 3v3 ( for VCC ) and GND ( for GND )…
Temt6000 is an analog sensor, and cannot be connected directly to the pi. You will need an ADC.