// This example shows how to connect to Cayenne using an Ethernet W5100 shield and send/receive sample data.

//#define CAYENNE_DEBUG
#define CAYENNE_PRINT Serial
#include <CayenneMQTTEthernet.h>
#include <Wire.h>
#include "Adafruit_HTU21DF.h"

Adafruit_HTU21DF htu = Adafruit_HTU21DF();

// Cayenne authentication info. This should be obtained from the Cayenne Dashboard.
char username[] = "username";
char password[] = "password";
char clientID[] = "clientID";

unsigned long lastMillis = 0;

void setup() {
  Serial.begin(9600);
  Cayenne.begin(username, password, clientID);
  htu.begin();
}

void loop() {
  Cayenne.loop();

  //Publish data every 1 seconds (1000 milliseconds). Change this value to publish at a different interval.
  if(millis() - lastMillis > 1000) {
    lastMillis = millis();
    //Write data to Cayenne here. This example just sends the current uptime in milliseconds.
    Cayenne.virtualWrite(0, lastMillis);

    Cayenne.virtualWrite(1, htu.readTemperature(), TYPE_TEMPERATURE, UNIT_CELSIUS);
    Cayenne.virtualWrite(2, htu.readHumidity(), TYPE_RELATIVE_HUMIDITY, UNIT_PERCENT);
    
  }
}

//Default function for processing actuator commands from the Cayenne Dashboard.
//You can also use functions for specific channels, e.g CAYENNE_IN(1) for channel 1 commands.
CAYENNE_IN_DEFAULT()
{
  CAYENNE_LOG("CAYENNE_IN_DEFAULT(%u) - %s, %s", request.channel, getValue.getId(), getValue.asString());
  //Process message here. If there is an error set an error message using getValue.setError(), e.g getValue.setError("Error message");
}