Trigger is not working

Bugs / Issues Resolved
47

Confirmed.

  1. create mqtt device
  2. connect to it (sketch below)
  3. add temp widgets with +
  4. create trigger when channel 5 is over 10 turn on channel 6
  5. delete channel 5 (has to be the source of the trigger, deleting destination doesn’t cause this bug)
  6. delete trigger
  7. add widget with + again
  8. recreate trigger
  9. trigger doesn’t ever fire

Code:

// This example shows how to connect to Cayenne using an ESP8266 and send/receive sample data.
// Make sure you install the ESP8266 Board Package via the Arduino IDE Board Manager and select the correct ESP8266 board before compiling. 

//#define CAYENNE_DEBUG
#define CAYENNE_PRINT Serial
#include <CayenneMQTTESP8266.h>

// WiFi network info.
char ssid[] = "";
char wifiPassword[] = "";

// Cayenne authentication info. This should be obtained from the Cayenne Dashboard.
char username[] = "";
char password[] = "";
char clientID[] = "";

int counter = 0;

unsigned long lastMillis = 0;

void setup() {
	Serial.begin(9600);
	Cayenne.begin(username, password, clientID, ssid, wifiPassword);
}

void loop() {
	Cayenne.loop();
  delay(1000);
  counter++;
}

// Default function for sending sensor data at intervals to Cayenne.
// You can also use functions for specific channels, e.g CAYENNE_OUT(1) for sending channel 1 data.
CAYENNE_OUT_DEFAULT()
{
	// Write data to Cayenne here. This example just sends the current uptime in milliseconds on virtual channel 0.
	Cayenne.virtualWrite(5, counter, "analog_sensor", "null");
	// Some examples of other functions you can use to send data.
	//Cayenne.celsiusWrite(1, 22.0);
	//Cayenne.luxWrite(2, 700);
	//Cayenne.virtualWrite(3, 50, TYPE_PROXIMITY, UNIT_CENTIMETER);
 Cayenne.virtualWrite(6, 0, "digital_actuator", "d");
}

// Default function for processing actuator commands from the Cayenne Dashboard.
// You can also use functions for specific channels, e.g CAYENNE_IN(1) for channel 1 commands.
CAYENNE_IN_DEFAULT()
{
	CAYENNE_LOG("Channel %u, value %s", request.channel, getValue.asString());
	//Process message here. If there is an error set an error message using getValue.setError(), e.g getValue.setError("Error message");
}
2 Likes