Submit Your Cayenne Projects! [contest ended]

[isaackoz130]

Here are the links:

Dog treat dispenser!

About This Project This is a dog treat dispenser controlled by a raspberry pi and an Arduino using Cayenne. This is a very basic design and is only a prototype. I do not have a 3d printer, so getting a design that dispenses treats was very hard. What’s Connected Items used: Arduino R3 raspberry pi 3 servo motor 10k resistor (I used ten 1k resistors in a series because I didn’t have a 10k on me) female and male wires some type of mechanism to dispense treats that uses a servo motor (3d print…

Dog Treat Dispenser

Dog Treat Dispenser Using Cayenne