Add led to cayenne

[mrcsollo]

With Raspberry pi 3 model b:

I run this tutorial and when I try to control the LED from the web page my widget say "Unreachable". Imgur: The magic of the Internet

Sorry for my poor english, but i’m italien.

[shramik_salgaonkar]

@mrcsollo welcome to cayenne community. you may be running on 4.9 kernel. but this bug was solved. @rsiegel tagging for this. till then try this:

GPIO dashboard

Hi @mike7 and welcome to the Cayenne Community. The issue is that webiopi, a component of the Cayenne Pi software, is not yet compatible with the 4.9 Linux Kernel. There are a few options to resolve this until we push an update with support for this kernel: If you have no specific need for the 4.9 kernel on your Pi (most people would not), you can downgrade to 4.4 by running this command (it will require a reboot after it runs) sudo rpi-update 52241088c1da59a359110d39c1875cda56496764 Aft…

[bestes]

Hi @mrcsollo,

Were you able to add LED? Would also be helpful to send picture of your setup.

~Benny