RPi 3B and 3B+ stretch install issue

[adam]

These threads might help you out:

Unable to install on raspberry pi 3

Ok, I think you had it above. I’m guessing if you run that command once more for dev, you’ll get a very small amount of space remaining? I’m not familiar with the parition scheme here… what also is the output from cat/etc/os-release ?

Installation on Rpi3B on usb-stick

Hi @brz25ac, I suspect the installer is getting stuck on an unnecessary step related to disk expansion, yes. Here is what I’d try: Run the installer again until it gets stopped where you pictured, then Ctrl+C to exit the script. If you run the command ls, there should be a folder called myDevices-1.0. Enter it with cd myDevices-1.0. From there, run sudo nano setup.sh to open the setup script for editing. Locate the following code block (around line 137) #make sure we have enough …